wc

1 shut off the water at the supply, turn the handle clockwise to the right until tight

2 flush water in tank down toilet, i recommend using a shot vac to vacuum out the remaining water on the bottom to prevent a mess

3 remove braided hose feeding fill valve, this should only be hand tight

4 remove nut thake secures the new valve to toilet with channel locks

5 install new valve, make sure rubber seal is on the inside of tank, tighten nut with channel locks

6 tighten braided hose on to valve hand tight

7 turn water back on slowly, place plastic tube in tank centre

8 check height of water and valve operation, flush a few times to make sure its operating properly

9 your new valve is now installed in less than 10 minutes

Original link